Radio And Television Interference - Nuvo NV-P100 Manual

Radio and Television Interference

This audio equipment generates, uses, and can radiate radio-frequency energy. If it is
not installed and used properly – that is, in strict accordance with NuVo's instructions
– it may cause interference with radio and television reception.
This equipment has been tested and found to comply with the limits for a Class B
digital device in accordance with the specification in Part 15 of FCC rules. These
specifications are designed to provide reasonable protection against such interference
in a residential installation. However, there is no guarantee that interference will not
occur in a particular installation.
You can determine whether your audio system is causing interference by turning it off.
If the interference stops, it was probably caused by the computer or one of the
peripheral devices.
If your audio system does cause interference to radio or television reception, try to
correct the interference by using one or more of the following measures:
•
Turn the television or radio antenna until the interference stops.
•
Move the audio device to one side or the other of the television or radio
•
Move the audio device farther away from the television or radio.
•
Plug the audio device into an outlet that is on a different circuit from the
television or radio. (That is, make certain the audio device and the television
or radio are on circuits controlled by different circuit breakers or fuses.)
If necessary, consult NuVo Technical Support, or see the service and support
information available for your NuVo product, or consult an experienced radio/television
technician for additional suggestions.
4