EzPro710
Service Manual
4.6 Disassemble Main Board and DMD Module
Main Board Bracket
( 61.81402.001 )
Snap Rivet
( 51.81429.001 )
1.
Unscrew two screws on the AV cover; unplug one connector and
remove the AV Board Module.
2.
Clip one Snap Rivet on the Main Board and take it off
3.
Unscrew two screws on the Main Board and remove the Main Board
4.
Unplug Color Wheel Control Cable from DMD Module and unscrew
four screws on the Front side of DMD-Module; unscrew two screws on
the Rear side of it; take off the Main Board Bracket
5.
Detach the DMD-Module and Optical Engine
4
3
2
EzPro 710 4-6
5
3
Main Board
( 80.81401.001 )
1
Label (35.81402.001)
Label (35.81403.001)
AV Board Module
(70.81409.001)
Optical Engine
( 70.81411.001)
DMD Module
( 75.81503.001 )
4
Service Manual