Step 5 - Level The Washer - Haier HLP21N User Manual

STEP 5 - LEVEL THE WASHER

IMPORTANT: Proper leveling of the washer will help reduce noise and vibration.
1. Stand the washer upright.
NOTE: If you installed casters, unlock them by lifting up on the tab.
2. Place washer in its final location. Check that the water and drain lines are not
strained or pinched. Make sure that all four feet are firmly in contact with the
floor and that the washer rests solidly in position.
3. Using a carpenter's level, check to make sure the washer is level from side to
side and from front to back.
4. If the washer is not level, adjust the leveling feet or casters. Turn clockwise to
extend (raise the washer) or counterclockwise to retract (lower the washer).
NOTE: If the washer is inclined more than 2°, it will not operate.
FIXED LEVELING FEET
1. Loosen the adjustable large, outer ring, and then turn the center foot clockwise
or counterclockwise to adjust the height.
Raise
2. Once the washer is level, lock the position of each leveling foot by tightening the
large, outer ring.
12
Lower
Outer Ring
Center Foot