Cd Mechanism Assembly Section; Removing The Cd Mechanism; Removing The Mechanism Control Board Assembly; Removing The Switch Board - JVC KW-XG56TU Service Manual

3.1.4 Removing the CD mechanism (See Fig.6)
(1) Remove the three screws L attaching the CD mechanism.
L
3.2

CD MECHANISM assembly section

• Remove the CD MECHANISM assembly from the main body.
3.2.1 Removing the MECHANISM CONTROL BOARD
assembly (See Fig.1 and 2)
(1) From the bottom side of CD MECHANISM assembly,
remove the solders from the soldered sections (a, b and
c) on the MECHANISM CONTROL BOARD assembly.

(See Fig.1.)

(2) Remove the three screws A attaching the MECHANISM
CONTROL BOARD assembly. (See Fig.1.)
b
a
A
1-10 (No.MA471<Rev.005>)
Fig.6
Mechanism
control board
CN102
A
c
A
Fig.1
3.1.5 Removing the Switch board (See Fig.7)
(1) Remove the Volume knob.
(2) Remove the sixteen screws M attaching the Switch board.
L
M
(3) Solder the short land sections on the pickup. (See Fig.2.)
Caution:
• Solder the short land sections on the pickup before
disconnecting the flexible wire from the connector
CN102 on the MECHANISM CONTROL BOARD as-
sembly.
If the card wire is disconnected without attaching
solder, the pickup may be destroyed by static
electricity. (See Fig.2.)
• When attaching the MECHANISM CONTROL
BOARD assembly, remove the solders from the
short land sections after connecting the flexible
wire to the connector
CONTROL BOARD assembly.
Mechanism control board
Flexible wire
M
Fig.7
CN102 on the MECHANISM
Short land section
CN102
Pickup
Fig.2
M