Physical Details; Front Panel; Rear Panel; Restore Default Ip Address And Clear Password - Planet ADE-3000 User Manual

Adsl bridge router

Hide thumbs Also See for ADE-3000:

Table of Contents

Physical Details

The front panel of ADE-3000 has 2 LEDs for one LAN port and one ADSL port. Figure

2 displays a front panel of the router.

LED definitions

Status ADSL

Status LAN

Button definition

Reset Button

If ADE-3000's IP Address or password is lost, the following procedure can be used to

recover from this situation.

Pressing the Reset button for more than 5 seconds. ADE-3000 will restore to factory

default setting. Note that this should be done only when you had tried all the

troubleshooting options. Pressing the Reset button during operation may bring you into

the risk of creating IP address conflict between your PC and the router. In such a case,

you may be compelled to reboot your entire system(s).

Figure 1-2: Front Panel

On – ADSL LED status will be on after chaining procedure

with DSLAM is completed

On –LAN LED will be on while RJ-45 connector is plugged

in.

Figure 1-3: Rear Panel

This button has two (2) functions:

When pressed and released, ADE-3000 will reboot

(restart).

When reset button is pressed over 5 seconds and

then release. ALL data will be clear and restore ALL

settings to the factory default values.

Introduction

Table of Contents