Appendix B Command Line Interface; Using The Cli - Telnet; Command Reference - Planet WDAP-2000PE User Manual

Appendix B
Command Line Interface
If desired, the Command Line Interface (CLI) can be used for configuration. This creat
possibility of creating scripts to perform common configuration changes.

Using the CLI - Telnet

1. Start your Telnet client, and establish a connection to the WDAP-2000PE.
e.g.
Telnet 192.168.1.1
2. You will be prompted for the password. Enter the same login password as used for the
HTTP (Web) interface.
The default values are password for the Password.
3. Once connected, you can use any of the commands listed in the following Command
Reference.
4. At any time, the users can type a "?" (preceded by a space) to request context-sensitive
help on what the user can enter next.
5. If a keyword is expected when the user types "?", all valid keywords will be displayed. The
command typed in so far will then be displayed again along with the cursor sitting at the end,
waiting for the user to continue.
6. If the user types in part of the keyword but does not type in the entire word, the user can
then enter a tab or space for the system to automatically complete the keyword if the char-
acters typed in so far can uniquely identify the keyword. If the characters typed in so far do
not uniquely identify a keyword, a list of possible keywords will be displayed.

Command Reference

The following commands are available.
(1) System Commands
Clear config
Description: Reset the system configuration to the factory default.
Disable upnp
Description: Disable the UPnP function.
Disable wlan management
Description: Disable the management function from a WLAN connected user.
enable upnp
Description: Enable the UPnP function.
enable wlan management
Description: Enable the management function from a WLAN connected user.
help
Description: Show help descriptions on CLI.
logout
Description: Logout the current CLI management session.
ping <IP address>
Description: Show help descriptions on CLI.
reset system
Description: Reboot the system. Any configuration not saved (e.g. by "save config") will be lost.
save config
Description: Save the current configuration onto the flash, so the configuration will be kept after
the system is rebooted.
set http port <port number, 1-65535>
B
es the
49