Planet VIP-157 User Manual page 15

Network settings via Keypad commands
The ATA series phone adapters support telephone keypad configurations, please connect analog
telephone set and refer to the following table for machine network configurations.
IVR Menu Choice
#111#
#112xxx*xxx*xxx*
xxx#
#113xxx*xxx*xxx*
xxx#
#114xxx*xxx*xxx*
xxx#
#115xxx*xxx*xxx*
xxx#
#136#
#137#
#195#
#198#
＊
Following keypad commands can be used to display the network settings enabled on ATA via voice
prompt.
IVR Menu Choice
#120#
#121#
#122#
Machine operation
Set DHCP client
Setup Static IP Address
Set Network Mask
Set Gateway IP Address
Set Primary DNS Server
Enable auto-config mode
Disable auto-config mode
Reboot
Factory Reset
To switch IP Phone mode
Machine operation
Check IP Address
Check network connection Type
Check the Phone Number
Parameter(s)
None
Use the * (star) key
when entering a decimal
point.
Use the * (star) key
when entering a decimal
point.
Use the * (star) key
when entering a decimal
point.
Use the * (star) key
when entering a decimal
point.
None
None
None
None
None
IVR will announce the current IP address of
the ATA.
IVR will announce if DHCP in enabled or
disabled.
IVR will announce current enabled VoIP
number.
Notes:
ATA will change to DHCP
Client
DHCP will be disabled and
system will change to the
Static IP type.
Must set Static IP first.
Must set Static IP first.
Must set Static IP first.
For PLANET IPX -2000 IP
PBX System
For PLANET IPX -2000 IP
PBX System
The system will reboot
automatically.
The system will be reset to
factory default value and
reboot automatically.
VIP-157 only
Notes:
15