Protech Systems BM-0947 User Manual page 105

III. BIOS update procedure
1. Use the bootable USB device to boot up system into the MS-DOS command
prompt.
2. Type in AFUDOS M947xxxx.bin /p /b /n /x
procedure.
Note: xxxx means the BIOS revision part, ex. 0PW1...
3. During the update procedure, you will see the BIOS update process status and its
percentage. Beware! Do not turn off system power or reset your computer if the
whole procedure are not complete yet, or it may crash the BIOS ROM and make
system unable to boot up next time.
4. After BIOS update procedures is complete, the messages should be like the
figure shown below:
C:\>afudos M9470TH6.bin /p /b /n /x
Copyright (C) 2012 American Megatrends Inc. All Rights Reserved.
Reading flash .............. done
- ME Data Size checking . ok
- FFS checksums ......... ok
Erasing Boot Block ......... done
Updating Boot Block ........ done
Verifying Boot Block ....... done
Erasing Main Block ......... done
Updating Main Block ........ done
Verifying Main Block ....... done
Erasing NVRAM Block ........ done
Updating NVRAM Block ....... done
Verifying NVERAM Block ..... done
C:\AFUDOS>
5. You can restart the system and boot up with new BIOS now.
6. Update is complete after restart.
'
BM-0947 USER S MANUAL
AMI Firmware Update Utility
Appendix B Technical Summary
and press enter to start the flash
v3.05.02
Page: B-19