Basic Operation; Turning Power On - Icom IC-F3032T Instruction Manual

■ Turning power ON

Prior to using the transceiver for the first time, the battery
pack must be fully charged for optimum life and operation.
(p. 17)
q Rotate [VOL] to turn ON the transceiver.
w If the transceiver is preset for a start up password, input
the digit codes as directed by your dealer.
• 10-keypad can be used for password input depending on ver-
sion:
• The keys in the table below can be used for password input:
• The transceiver detects numbers in the same block as identi-
cal. Therefore "01234" and "56789" are the same.
[VOL]
[Side3]
NUMBER
[P0]/[P1]/
[P2]/[P3]
e When the "PASSWORD" indication does not clear after
inputting 4 digits, the input code number may be incorrect.
Turn OFF the transceiver and start over in this case.
KEY Side3
0 1 2 3 4
5 6 7 8 9

BASIC OPERATION

D Battery type selection
The battery type must be selected according to the attaching
battery type when turning ON the transceiver.
Ask your dealer for details.
q Turn OFF the transceiver.
w While holding down [Emer] and [PTT], turn the power ON
with rotating [VOL] to toggle the attaching battery type.
• After the battery type is displayed, release [Emer] and [PTT].
• "DRY BATT" is displayed for about 3 seconds then "L" is dis-
played when the battery case operation is selected. In this
case, the transmit output power is low.
• "LI-ION" is displayed for about 3 seconds when the Lithium-ion
battery operation is selected.
[VOL]
[Emer]
[PTT]
3
Displayed
Dry battery mode
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
8