Table of Contents
Advertisement
Drivers Guide
40
ETEQ Drivers Installation Guide
Part 1 : AGP Card
Follow the steps below to install the software for AGP VGA card :
1. Install Windows 95 OSR2 to your hard drive.
2. Browse the OSR2 CD-ROM after you successful install your system.
3. Change the directory to \OSR2\USBSUPP.
4. Excute the USBSUPP.EXE file to solve the question mark on USB under Device
Manager.
5. Install the drivers that came with your AGP VGA card.
6. Restart your system.
7. Install DIRECT X 5 to the system.
8. Restart your system.
9. Shell to DOS prompt.
10. Make a new directory "VXD"
11.Find the ETEQVXD.EXE file from the floppy/CD-ROM that came with your
motherboard.
12. Copy this file to the VXD directory.
13. Excute it and follow the instructions on screen.
14. Restart your system.
15. Open "Microsoft DirectX-5 SDK" icon then double click on "DirectX Viewer"
16. Switch to "DirectDraw Devices" then check if you can see any digit on the items
below :
"Video", "Video [Local]", "Video [non-Local], and "Texture". If you can see the digits
on these items, AGP VGA drivers are installed successfully.
Part 2 : South Bridge Identify Issue
ETEQ south bridge chipset can not be identified by Windows 95 and so it shows two
question marks under Device Manager. Therefore, we provide drivers for you to solve
this problem. Please find the ETEQACPI.EXE file from the floppy/CD-ROM that came
with your motherboard and install it.
Part 3 : IDE Bus Master/Ultra DMA Drivers
If you have IDE devices that support Bus Master or Ultra DMA function, you need to
install the drivers to enable these functions. Please find the ETEQIDE4.EXE file from the
floppy/CD-ROM that came with your motherboard and install it.
Advertisement
Table of Contents
