Table of Contents
Advertisement
28
PM Control by
APM
Video Off Option
Video Off Method
Conserve Mode
HDD Power Down
Doze Mode
Suspend Mode
VGA
Choose Yes (default) or No. APM stands for
Advanced Power Management. To use APM,
you must run Òpower.exeÓ under DOS v6.0 or
later version.
Susp, Stby→off:Video off when the system
All Modes→off: Video off in all modes.
Always On:
Suspend→off:
Choose V/H Sync+Blank (default), Blank
screen, or DPMS for the selected PM mode.
Use the default setting.
When the set time has elapsed, the BIOS sends a
command to the HDD to power down, which
turns off the motor. Time is adjustable from 1 to
15 minutes. The default setting is Disabled.
Some older model HDDs may not support this
advanced function.
When the set time has elapsed, the BIOS sends a
command to the system to enter doze mode
(system clock drops to 33MHz). Time is
adjustable from 10 seconds to 1 Hour.
The default is Disabled. Only an SL-Enhanced
(or SMI) CPU can enter this mode. Time is
adjustable from 10 seconds to 1 Hour. Under
Suspend mode, the CPU stops completely (no
instructions are executed.)
Choose Off (default) or On to disable or enable
the power management.
runs into Suspend or Standby
mode.
Video never off.
Video off when system runs
into the suspend mode.
BIOS Setup
Advertisement
Table of Contents
