Table of Contents
Advertisement
34
IDE Primary Master PIO/
IDE Primary Slave PIO/
IDE Secondary Master
PIO/
IDE Secondary Slave PIO
IDE Secondary Master
UDMA
IDE Secondary Slave
UDMA
Onboard FDC Controller
Onboard UART 1/
Onboard UART 2
Onboard UART 2 Mode
IR Duplex Mode
Onboard Parallel Port
Choose Auto (default) or mode 0~4.
Mode 0 is the slowest speed, and HDD
mode 4 is the fastest speed. For better
performance and stability, we suggest
you use the Auto setting to set the HDD
control timing.
Choose Auto (defautl) or Disabled.
When Auto is selected, it supports Ultra
DMA Mode.
Enabled Ð
Use the on-board floppy
controller (default).
Disabled Ð Turn off the on-board
floppy controller.
Choose serial port 1 & 2Õs I/O address.
Do no set port 1 & 2 to the same value
except for Disabled.
COM 1/3F8H
COM 2/2F8H
(default)
Standard Ð (default) supports a serial
infrared IrDA.
HPSIR Ð
supports HP serial infrared
interface format
ASKIR Ð
supports a Sharp serial
interface format.
Use the default setting (Half). This
function shows up only when either
HPSIR or ASKIR is chosen in the
previous function (Onboard UART 2
Mode).
Choose the printer I/O address:
378H/IRQ7 (default), 3BCH/IRQ7,
278H/IRQ5
BIOS Setup
| COM3/3E8H
| COM4/2E8H
Advertisement
Table of Contents
