Jp22: Cpu Burst Mode Jumper; Jp1: Smart Detect Cpu Voltage Auto/Manual Jumper - SOYO 5ED5 User Manual

6

JP22: CPU Burst Mode Jumper

Due to different designs, there are two kinds of CPU burst modes:
Interleave Burst and Linear Burst. Select the correct mode according to
the CPU you are using.
(for P54C/P55C and AMD
(for Cyrix 6x86/L/MX CPU)
When using a Cyrix series of CPUs, follow the below procedures after
select the burst mode:
1. Press<Delete> key to enter the BIOS setup menu during the boot-up,
2. Select ÒChipset Features SetupÓ,
3. Set the ÒLinear BurstÓ to ÒEnabledÓ,
4. Press <Esc> to go back to the main menu and choose ÒSave & Exit
SetupÓ to reboot your computer.

JP1: Smart Detect CPU Voltage Auto/Manual Jumper

For P54C/P55C and Cyrix 6x86/L CPUs, this board automatically
detects and adjusts the CPU voltage to the proper voltage. JP1 is
reserved for a few older non-Intel CPUs which can not be detect
correctly. If you run into problems while detecting the voltage of older
CPUs, remove the jumper cap to correct it.
CPU Burst Mode
Interleave
K5/K6 CPU)
Linear
Hardware Setup
JP22
1 2 3
1 2 3