TrekStor PRIMETAB P10 Operating Instructions Manual page 32

c) Also press the On/off switch and hold both buttons down.
d) As soon as the TrekStor logo appears, release both buttons.
A few moments later the recovery mode menu appears.
Use both volume control buttons to navigate in recovery mode. Briefly press the
On/off switch on the device to select an option.
Proceed as follows to load factory settings:
WARNING
If you load factory settings, all the files saved on your Primetab (photos, text files,
bookmarks, apps etc.) and all the settings you have configured (background,
passwords etc.) will be deleted!
a) Navigate to "Wipe data / factory reset".
b) Confirm your selection by briefly pressing the On/off switch. A new
window appears in which you will be asked this question in red: "Wipe all
data? THIS CAN NOT BE UNDONE!"
c) Navigate to "Yes" and confirm your selection by briefly pressing the On/off
switch.
d) Navigate to "Reboot system now" in the following window and confirm
your selection by briefly pressing the On/off switch.
The Primetab now exits recovery mode, deletes all data, loads the factory
settings and then starts as normal.
As soon as the process is finished, the configuration assistant appears just like
the first time you started using your Primetab.
32