HEIDENHAIN POSITIP 850 Operating Instructions Manual page 11

Enter the program number of the program to be transferred. If necessary. call up
the directory of programs on the diskette using the soft key FE 401 PGM Dir (see
"Program Output").
Installation
1 Connections and Controls (Rear of Unit)
ID plate
Sohware Number
］ Ｚ Ｚ Ｚ ｔ Ｇ Ｍ ］ ］ ｾ Ｍ Ｂ ｌ Ｎ Ｚ ｴ Ｚ Ｚ ｲ ］ ｉ ］ ｇ ａ ｡ ｮ ｧ ･
sockets
X4. X3. X2. Xl
Inputs for linear
and
angle
encoders
Sub D cormeetion X41 IEXT) Conmtct,on fOf Sub,D Socket X31
External
funct,ons
protectIVe ground Data output
Sub.D socket Xl 0
Input for
touch
probe
system
Start transfer of program from floppy disk unit to
POSITIP.
c
Start
Input
The buffer batteries (three AA size 1.5 V batteries) serve as a power supply fOf the
program memory. Exchange the batteries if the error message EXCHANGE
BUFFER BATTERY appears.
The unit must be switched on during battery exchange to prevent erasure
of stored programs.
h is very important that you follow this sequence of steps
when installing the unrt for the first time.
Do not engage or disengage any conneclOrs while 'he unit is
under power.
W14 Working with the POSITIP 850
Installation 11