JVC MX-J270V Service Manual page 6

MX-J270V
Removing the CD changer mechanism
assembly
Prior to performing the following procedures, remove
the metal cover.
1. Disconnect the card wire from connector CN308 and
CN309 connecting the CD servo board and the main
board.
2. Disconnect the harness from CN310 on the main
board.
3. Remove the two screws C attaching the CD changer
mechanism assembly on the top of the body.
4. Remove the plastic rivet a fixing the main board to
the front panel assembly on the left side of the body.
5.
Remove the two screws D from the rear panel.
6. Cut off the band b and band c which bundle two
harnesses coming from the MIC/headphone board
and one harness coming from the video board,
respectively.
7. Detach upward the rear part of the CD changer
mechanism assembly while pulling the front panel
assembly and the rear panel outward, then pull out
the front part backward and upward.
1-6
(See Fig.4 to 7)
CD changer
mechanism
assembly
Plastic rivet a
Front panel
assembly
Rear panel
Pull outward
Band c
Fig.4
CD changer mechanism assembly
CN310
CN309
Fig.5
Fig.6
CD changer mechanism
Band b
Fig.7
Main board
CN303
C
CN308
Rear panel
Main board
D
Rear panel
assembly
Front panel
assembly
Pull outward
Main board