JVC MX-J270V Service Manual page 16

MX-J270V
Removing the actuator motor board
1. Absorb the four soldered positions "q" of the right and
left motors with a soldering absorber(See Fig.14).
2. Remove the two screws G retaining the actuator motor
board(See Fig.14).
3. Remove the two screws H retaining the tray select
switch board(See Fig.15).
Removing the cam unit
1. Remove the CD mechanism assembly.
2. While turning the cam gear r, align the pawl "s" position
of the drive unit to the notch position(Fig.15) on the cam
gear r.
3. Pull out the drive unit and cylinder gear(See Fig.17).
4. While turning the cam gear r, align the pawl "t" position
of the select lever to the notch position(Fig.18) on the
cam gear r.
5. Remove the four screws I retaining the cam unit(cam
gear r and cams R1/R2 assembly)(See Fig.18).
Chassis assembly
CN801
Fig.15
1-16
(See Fig.14, 15)
(See Fig.15 to 18 )
Tray select
switch board
CN802
CN804
Drive unit
Cylinder gear
Fig.17
Motor L
q
Actuator motor board
Fig.14
Drive unit
s
H
Fig.16
Cams R1, R2 assembly
I
Cam gear L
I
t
Select lever
Fig.18
G
Motor R
q
G
Cam gear r
Cam unit
I