Table of Contents
Advertisement
REMEMBER!
To leave the Programming
Mode at any time, press
the Esc key. Doing so will
return the CP-220A to its
normal operating mode.
Programming changes will
be stored automatically.
Parameters in Category B:
Printer Operation
PARAMETER 01:
Printer I/O
PARAMETER 35:
Printer
Feed
PARAMETER 38:
Printer
Manual Mode
PARAMETER 41:
Message
Spaces
PARAMETER 34:
Test Character
PARAMETER 43:
Auto Message
9.
Press the NEXT key or the MANUAL/PREVIOUS key until [HI/LO]
appears.
10. Press the
key to select another slot to program, or the Esc key to
leave the programming mode. If programming another slot, repeat each
of the previous steps.
NOTE 1:
Pressing the N key too many times will cause you to leave
PARAMETER 62 prematurely. If that happens, simply re-enter
PARAMETER 62 by pressing 6 and then 2 .
NOTE 2: In the above example, be sure that two Hi/Lo handshakes have
been programmed in PARAMETER 07.
Default:
All 8 slots have been factory-programmed with [NONE] as the first
handshake. See the table on the previous page for additional clarification.
Advancing to Next Parameter:
The next parameter is the first in Category B, Printer Operation, and is
PARAMETER 01. Because it is not sequential, it cannot be reached with a
single press of the
PARAMETER 62, press the N key until [PARAMETER NUMBER 62]
appears, with its first digit flashing. Then press 0 and 1 .
Category B: Printer Operation
This material will cover the programming of the parameters found in
Category B, Printer Operation. As stated on page 2-1, three distinct
categories have been selected into which each of the CP-220A's
Line
programming parameters have been placed. Programming the
CP-220A's parameters according to category, rather than by
Fail
numerical sequence, is thought to be a more logical approach and is
generally easier.
A complete guide to programming all the parameters in Category B
(see column at left) will be covered here. In the discussion of each
parameter, you will be provided with:
• background information
• programming options
• an explanation of the default
• the next logical parameter in Category B
If you are about to program Category B parameters after leaving
PARAMETER 62 (above), proceed to the following page. However, if you are
first beginning to program at this point, you may wish to refer back to
Entering and Using the Programming Mode, on pages 2-5 through 2-7,
before continuing .
CP-220A Central Station Receiver Section 2: Programming the CP-220A Page 2-63
Hook-Up and Installation Manual
key. To advance to PARAMETER 01 from
Hide quick links:
Advertisement
Table of Contents
