Pioneer VSX-D908S Operating Instructions Manual page 73

MULTI-ROOM set up
After you have completed the necessary connections for MULTI-ROOM operation you need to set up the
receiver for such operation. Follow the instructions below. The following page explains how to use the MULTI-
ROOM function once it's set up.
Î
S0URCE RECEIVER
MULTI SYSTEM
OPERATION OFF
DVD/LD TV/SAT VCR1 VCR2
MULTI CONTROL
MD/
CD TUNER TV CONT
TAPE1
CLASS MPX BAND DIRECT ACCESS
7 3 8
¶
- + - +
TUNING STATION
1 ¡ 4 ¢
- +
CHANNEL
DTV ON/OFF DTV MENU
1 2 3
5 6
4
8 9
7
GUIDE EXIT
0
ENTER
+10 DISC
TV
TV VOL VOLUME
TV CONTROL
TV FUNC
EFFECT
MENU MUTE
/CH SEL
FUNCTION
ENTER
SIGNAL
SELECT
2,6
2/dts
SYSTEM
ADVANCED STANDARD
SETUP
REMOTE
MIDNIGHT DSP STEREO
SETUP
DIGITAL NR
DIGITAL MULTI PROCESSING AMPLIFIER
REMOTE CONTROL UNIT
1
Turn on your TV and the receiver.
1
Make sure your TV is set to the receiver.
2
Press SYSTEM SETUP on the remote control.
The REMOTE SETUP MENU appears on your TV screen. You can
escape from this screen at any time by pressing SYSTEM SETUP
again.
1
3,4,5
3 Use the 5¥∞ buttons to select the MULTI-ROOM set
up mode and press ENTER.
4 Select the VOLUME LEVEL by using the 2¥3 buttons.
If you hook up a just a power amplifier in the sub room the VSX-
D908S will act as a pre-amp. In this case choose VARIABLE for the
VOLUME LEVEL setting. If you hook up a full integrated amplifier in
the sub room (such as another Pioneer VSX receiver) choose FIXED
for the VOLUME LEVEL setting.
5 Select the IR RECEIVER type with the 5¥∞ buttons
and select the type by using the 2¥3 buttons.
If you have the Pioneer-made MR-100 select PIONEER. If you have
an IR RECEIVER from a different company, select OTHER.
6
Move to the EXIT setting and press ENTER to exit
MULTI-ROOM set up and return to normal operations.
You can leave the MULTI ROOM set up mode any time by pressing
the SYSTEM SETUP button.
Some IR RECEIVERS may not work with this system, check
with a PIONEER representative to be sure.
CAUTION!
If the MULTI ROOM is set to FIXED the volume on the main unit
will be set to maximum. Thus, when output, it will be extremely
loud. Please set the master volume controls of the integrated
amplifier in the sub room very low at first and experiment to find the
correct volume.
Using Other Functions
Multi-Room
Volume Level
[VARIABLE]
IR Receiver
[PIONEER]
[EXIT]
CAUTION : If the "FIXED"
position is chosen, the
volume will be loud.
73