Front Panel - Pioneer VSX-D908S Operating Instructions Manual

Displays & Controls

Front Panel

All the controls on the front panel are explained and/or referenced here. To open the front panel push gently on
the lower third of the panel.
1
3
¢
1
STANDBY/ON button
Press to switch the receiver ON or into STANDBY
mode.
2 STANDBY indicator
Lights when the receiver is in STANDBY mode.
(Please note that this receiver consumes a small
amount of power (1.0 W) during the standby
mode.)
3 SIGNAL SELECT button (See p.40)
Use to select the signal from the digital
components.
SIGNAL SELECT repeatedly to select one of the
following:
ANALOG : To select an analog signal.
DIGITAL : To select a optical or electrical digital
signal.
4 DSP MODE button (See p.37-38)
Press repeatedly to select a DSP sound mode.
(HALL 1, HALL 2, JAZZ, DANCE, THEATER 1, or
THEATER 2). Use these modes to produce
surround sound from standard (two channel)
stereo sources and create different listening
environments.
5 STEREO button (See p.37-38)
Press to select the STEREO sound mode. In this
mode, sound comes from the front (left and right)
speakers only.
20
2 4 5 6
N∫m¿ /?˘∫
Digital Signal Processor
AUDIO/VIDEO MULTI-CHANNEL RECEIVER
STANDBY/ON
DSP
STANDBY STEREO
MODE
/DTS
SIGNAL SELECT ADVANCED STANDARD
~ ! @ # $
5-CHANNEL EQUAL POWER OUTPUT EXTERNAL
DECODER IN
VIDEO INPUT
S-VIDEO VIDEO L AUDIO R
PHONES
SPEAKERS
£ ™
7 8 9 0
MULTI-ROOM
& SOURCE
CONTROL
%
DIGITAL FL
DIRECT LOUDNESS MIDNIGHT NR DIMMER CLASS
TAPE 2
– BASS + – TREBLE + INPUT ATT MONITOR MPX
¡ + _ ) (
6 2/DTS buttons (See p. 36, 38 & 77-78)
ADVANCED THEATER : Press to select one of
the four Advanced Theater modes.
STANDARD : Press for pure decoding of multi
channel sources.
7 Display (See page 18)
8 Remote sensor
Point the remote control toward the remote
sensor to operate the receiver.
9 MULTI-ROOM & SOURCE button (See
p.72-76)
Press to enable multi room operation (requires an
optional PIONEER Multi-Room Remote Sensor
Unit MR-100 or other IR receiver).
0 CONTROL button (See p.72-76)
Use to select the function or volume of the
MULTI ROOM system.
- =
INPUT
SELECTOR
MASTER
VOLUME
DOWN UP
^
TUNER CONTROL
FM/AM – TUNING +
MEMORY – STATION +
* &