Pioneer VSX-D908S Operating Instructions Manual page 30

Surround Sound Set Up
S0URCE
OPERATION
DVD/LD TV/SAT
CD
CLASS
¶
-
TUNING
1
DTV ON/OFF DTV MENU
1
4
7
GUIDE
+10
TV VOL
TV CONTROL
EFFECT
/CH SEL
3,4
SYSTEM
SETUP
REMOTE
MIDNIGHT
SETUP
DIGITAL MULTI PROCESSING AMPLIFIER
REMOTE CONTROL UNIT
It is possible to set channels
levels independently for
Surround/dts, STEREO,
EXTERNAL DECODER and
each DSP mode for listening-
once purposes (see p.22 6).
This function is designed to
be used when you want to
change the levels temporarily
to hear one speaker louder.
You should return the
settings to their original state
when done.
30
3
Î
RECEIVER
MULTI SYSTEM
OFF
VCR1 VCR2
MULTI CONTROL
MD/
TUNER TV CONT
TAPE1
MPX BAND DIRECT ACCESS
7 3 8
+ - +
STATION
¡ 4 ¢
- +
CHANNEL
2 3
5 6
8 9
EXIT
0 ENTER
DISC
TV
VOLUME
TV FUNC
MENU MUTE
FUNCTION
ENTER
SIGNAL
SELECT
2/dts
ADVANCED STANDARD
DSP STEREO
DIGITAL NR
4
5
6
After selecting SETTING START with the button
press ENTER. The TEST TONE will be output.
These settings will be displayed on your TV.
Channel Level
Test Tone
[Setting OK
Front
Center
Front
Surround
Surround
Subwoofer
SIGNAL
SELECT
ANALOG SP A
AUTO
It takes a moment for the machine to set itself. MASTER VOLUME
rotates to the reference position (0dB), and the test tone is output.
To exit before outputting the TEST TONE
Press ENTER.
To exit while outputting the TEST TONE
Press ENTER.
Adjust speaker levels so that you hear the test tone at
the same volume from each speaker when seated in
your main listening position.
NOTE : The volume of the sub-woofer tends to sound lower than it
actually is, you may need to raise its level after testing the sound
with actual soundtracks.
In AUTO mode
1 Press 2 or 3 to adjust the level of the speaker outputting the
TEST TONE.
In MANU mode
1 Press 2 or 3 to adjust the level of the first speaker.
2 Press 5¥∞ to switch the TEST TONE to the next speaker.
3 Repeat 1 and 2 for each speaker.
If you are using a Sound Pressure Level (SPL) meter
Take the readings from your main listening position and adjust the
level of each speaker to 75 dB SPL (C-weighted/slow model).
When you have adjusted each speaker level, select
SETTING OK and press ENTER to return to the
previous screen
The MASTER VOLUME will return to its original position.
Next, proceed to CROSSOVER NETWORK below.
If you want to change a setting before proceeding.
Simply use the arrow buttons to go back.
Select EXIT with the 5¥∞ buttons and press ENTER to
return to the SYSTEM SETUP MENU.
[ AUTO ]
]
L [ 0dB]
L
[ 0dB]
[ 0dB]
R
[ 0dB]
R
[ 0dB]
L
[ 0dB]
STEREO
VOLUME
dB