Mute Button - Pioneer VSX-D908S Operating Instructions Manual

8 SYSTEM SET UP button
Use to set up the speaker and sound systems.
For more information see "Surround Sound
Setup" starting on p. 24.
9 REMOTE SETUP button.
Use to customize the remote control functions
and the remote control itself. (See "Setting Up
the Remote Control to Control Other
Components" starting on p.50, "Multi
Operation" starting on p. 65.)
To access the EXTERNAL DECODER option,
press the REMOTE SETUP button and the
SIGNAL SELECT button simultaneously.
0 MIDNIGHT button (See p. 42)
Switches the MIDNIGHT LISTENING mode on or
off.
- MULTI OPERATION button
Use this button to start the MULTI OPERATION
mode. See p. 65 for how to program and use the
MULTI OPERATION mode.
= SYSTEM OFF button
This button turns off components in two ways.
First, when pressed it will turn off all PIONEER
components. Secondly, any component that has
programmed into the MULTI OPERATIONS
settings will also be turned off. (see p. 67).
For example : If you programmed power on for
your TV and VCR, pressing the SYSTEM OFF
button will turn off these components even if
they are not PIONEER products.
~
RECEIVER button
Press to turn power of the receiver on or to
STANDBY (off).
! Number buttons
These buttons can perform a variety of different
functions depending on the remote operation
mode. They are most useful for CD and tuner
operations.
@ ENTER/EXIT/DISC button
These buttons can perform a variety of different
functions depending on the remote operation
mode.
# MASTER VOLUME button
Use to raise or lower the volume of the receiver.

$ MUTE button

Press to mute or restore the volume.
% FUNCTION button
Press to select a source. The button will cycle
through all the possible sources.
Displays & Controls
^ SIGNAL SELECT button
Press SIGNAL SELECT repeatedly to select one
of the following:
ANALOG : To select an analog signal.
DIGITAL : To select a digital signal (DVD/LD,
TV/SAT, CD, MD/TAPE 1, VCR 1, VCR 2).
Press the SIGNAL SELECT and REMOTE SETUP
buttons simultaneously to switch from the
SIGNAL SELECT operation to EXTERNAL
DECODER operation. Then press the button to
get the EXTERNAL DECODER function. To get
back to the SIGNAL SELECT control, press the
REMOTE SETUP button and the SIGNAL SELECT
button simultaneously once again.
& 2/dts buttons (See p.38)
Press these buttons to put the receiver in the
selected sound mode. For more information on
the modes .
* STEREO/DIGITAL NR button
STEREO : Press this button to put the receiver
into stereo mode when it's in a different sound
mode. For more information on the sound modes
see p.38.
DIGITAL NR : Switches the DIGITAL NR on or off
(see p.41).
( DSP button (See p.38)
Press repeatedly to select a DSP sound mode.
23