Pioneer VSX-818V-K Operating Instructions Manual page 65

Other Settings
Assigning the component video inputs
• Default settings:
Component 1 – DVD
Component 2 – TV
Component 3 – DVR
If you used component video cords to connect
your video equipment you must tell the receiver
which device it is, or else you may see the
composite video input instead of the
component video signal. For more on this, see
Using the component video jacks on page 16.
1 Select 'Component Input' from the Input
Assign menu.
4. Input Assign
a.Digital Input
b.Component Input
c.HDMI Input
:Return
2 Select the number of the component
video input to which you've connected your
video component.
The numbers correspond with the numbers
beside the inputs on the rear of the receiver.
3 Select the component that corresponds
with the one you connected to that input.
Select between DVD, TV, DVR or OFF.
• Use and ENTER to do this.
• If you assign a component input to a
certain function, any component inputs
previously assigned to that function will
automatically be switched off.
• Make sure you have connected the audio
from the component to the corresponding
inputs on the rear of the receiver.
• If you connect any source component to
the receiver using a component video
input, you should also have your TV
connected to this receiver's component
video MONITOR output (down converting
component video is not possible after
assigning an input).
4 When you're finished, press RETURN.
You return to the Input Assign menu.
4b.Component Input
Component–1 DVD
Component–2 [ TV ]
Component–3 [ DVR ]
:Finish
Assigning the HDMI inputs
• Default settings:
HDMI - 1 – DVD
HDMI - 2 – TV
If you used HDMI to connect your video
equipment, you must tell the receiver which
input terminal(s) you have used, so that you
see the proper video signal when you select
the input source.
1 Select 'HDMI Input' from the Input Assign
menu.
4. Input Assign
a.Digital Input
b.Component Input
c.HDMI Input
2 Select the number of the HDMI input to
which you've connected your video
component.
The numbers correspond with the numbers
beside the inputs on the rear of the receiver.
3 Select the component that corresponds
with the one you connected to that input.
Select between DVD, TV, DVR or OFF.
• Use and ENTER to do this.
• If you assign an HDMI input(s) to a certain
function, any HDMI inputs previously
assigned to that function will automatically
be switched off
• VSX-818V model only: To hear audio from
your HDMI component (through this
system), you must also make separate
audio connections to the corresponding
inputs on the rear of the receiver. For more
on this, see Connecting using HDMI on
page 16.
• If you connect any video component to the
receiver using HDMI, you should also have
your TV connected to this receiver's HDMI
output.
4 When you're finished, press RETURN.
You return to the Input Assign menu.
11
:Return
65
En