Display Section - Pioneer VSX-425 Operating Instructions Manual

io MPX MODE buttons
Auto stereo mode:
Normally, leave in this mode for reception, When a
stereo FM broadcast
is received, it will be automatically
reproduced in stereo.
Monaural mode:
When receiving distant stations or stations with weak
broadcast signals, the input signal may be weak, thus
resulting in increased noise during FM stereo broad-
casts. In this event, setting the receiver to the monaural
mode will reduce the noise. In this case, however, FM
stereo broadcasts will be reproduced in monaural sound.
NOTE:
This butten has no effect on reception of AM broadcasts.
ii Remote sensor
12 Display section
13 CLASS button
Use to switch between preset memory classes 7 to 3. In
each class, one station can be memorized in each of the
1 to 10 stations, enabling a total of 30 stations to be
memorized.
4: FM/AM button
Use this to switch between FM and AM frequency band
reception,
a5 TUNING buttons
+: Performs tuning from the currently displayed station
frequency in ascending frequency order.
~! Performs tuning in order of descending frequencies.
Aute tuning (FM only}:
Press TUNING + (up) or = (down) button until the frequen
cy starts to change, then release it. The tuner will auto-
matically search for a broadcasting station and stops
when one is found, and the TUNED indicator lights up. To
search for another station, press again,
Manual tuning:
Press TUNING + (up) or - (down) button and release
quickly. The tuning frequency will change by one step
each time the button is pressed. Press as many times as
necessary to tune in the desired station. The TUNED
indicator lights up when the statin is tuned in best.
e If you keep the TUNING (+/-) button depressed after
the frequency has began to change, the reception
frequency changes continuously, and stops when the
button is released.
NOTE:
When AUTO TUNING is in use, reception may not be possible
over jong distances or when signals are weak. At these times
MANUAL TUNING is recommended.
16 STATION (+,-) button
+: Use to cail preset station numbers in ascending order.
~: Use to call preset station numbers in descending order.
17 BASS control
Use to adjust the low-frequency Jevel. Turn clockwise to
boost bass and counterclockwise to attenuate bass.
a8 TREBLE control
Use to adjust the high-frequency level. Turn clockwise to
boost treble and counterclockwise to attenuate treble.
9 BALANCE control
Use to adjust the sound volume balance between left and
right speakers.
L : Decrease the sound on the right side.
R_ : Decrease the sound on the left side.
Usually, left and right volume levels should be the same.
DISPLAY SECTION |
A B i ©)
Geass src (PROLOGIE]) [TAPED (ELAS (H)
'ii wen fh
FM IAM
wa Wa Wy
NE
i i
42
<ARB7066>