Table of Contents
Advertisement
09
MULTI-ZONE remote controls
Press the remote control's ZONE 2 to operate the ZONE 2.
The following table shows the possible MULTI-ZONE remote controls:
Button(s)
What it does
Switches on/off power in the sub zone.
u
INPUT SELECT
Use to select the input function in the sub zone.
Use to select the input function directly (this may not work for some functions) in the sub
Input function buttons
zone.
VOLUME +/–
Use to set the listening volume in the sub zone.
<a>
MUTE
Mutes the sound or restores the sound if it has been muted (adjusting the volume also
<a>
restores the sound).
a In case of VSX-1127
The volume cannot be adjusted on the receiver if Volume Level at ZONE 2 Setup under ZONE Setup is set to –40 dB Fixed or
0 dB Fixed.
In case of VSX-1027
You can only use this button when Speaker System is set to ZONE 2.
Using the sleep timer
The sleep timer switches the receiver into standby after a specified amount of time so you can fall asleep without
worrying about the receiver being left on all night. Use the remote control to set the sleep timer.
%
Press
to the receiver operation mode, then press SLEEP repeatedly to set the sleep
time.
30 min
Off
! You can check the remaining sleep time at any time by pressing SLEEP once. Pressing repeatedly will cycle
through the sleep options again.
! The sleep timer is valid for all zones. If any zone is on, the sleep timer continues functioning.
Dimming the display
You can choose between four brightness levels for the front panel display. Note that when selecting sources, the
display automatically brightens for a few seconds.
%
Press
to the receiver operation mode, then press DIMMER repeatedly to change the
brightness of the front panel display.
! You can also choose to turn the display off. In this case, the FL OFF indicator lights.
60 min
90 min
Checking your system settings
Use the status display screen to check your current settings for features such as surround back channel process-
ing and your current MCACC preset.
1
Press
to the receiver operation mode, then press STATUS to check the system
settings.
The front panel display shows each of the following settings for three seconds each: Input Source d Sampling
Frequency d MCACC preset d ZONE 2 input.
2
When you're finished, press STATUS again to switch off the display.
Resetting the system
Use this procedure to reset all the receiver's settings to the factory default. Use the front panel controls to do this.
Set MULTI-ZONE to MULTI ZONE OFF.
! Disconnect the iPod and USB memory device from the receiver beforehand.
! Set the Control with HDMI to OFF (see
HDMI Setup
1
Switch the receiver into standby.
2
While holding down ENTER on the front panel, press u STANDBY/ON.
The display shows RESET c NO d.
3
Select 'RESET' using PRESET k/l, then press ENTER on the front panel.
The display shows RESET? OK.
4
Press ENTER to confirm.
OK appears in the display to indicate that the receiver has been reset to the factory default settings.
! Note that all settings will be saved, even if the receiver is unplugged.
Default system settings
Setting
Digital Video Converter
SPEAKERS
Speaker System
Front
Center
FH/FW
Speaker Setting
Surr
SB
SW
Surround Position
Crossover
X-Curve
DIMMER
Inputs
See
Input function default and possible settings
on
HDMI
HDMI Audio
63
Using other functions
on
page
55).
Default
ON
SB/FH
Normal(SB/FH)
SMALL
SMALL
SMALL
SMALL
SMALLx2
YES
IN REAR
80 Hz
OFF
Brightest
page
35.
Amp
Advertisement
Table of Contents
