Resetting The System; Default System Settings - Pioneer VSX-LX51 Operating Instructions Manual

Using other functions

Resetting the system

Use this procedure to reset all the receiver's settings to
the factory default. Use the front panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the front panel STEREO/A.L.C
button, press and hold  STANDBY/ON for about two
seconds.
The display shows RESET?.
3 Press the front panel AUTO SURR/STREAM DIRECT
button.
The display shows OK.
4 Press HOME THX to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
• Note that all settings will be saved, even if the
receiver is unplugged.

Default system settings

Setting
HDMI Audio
HDMI Control
Digital Video Conversion
Speakers
Surround Back System
Speaker System Front
Center
Surr
SB
SW
Crossover
X-Curve
THX Audio Setting
Inputs
See Input function default and possible settings on page 66.
MULTI-ZONE
Zone 2 Volume Type
Zone 2 Volume
SR+
SR+ Control On/Off
SR+ Volume Control On/Off
Monitor Out
DSP
Surround back channel Processing
Phase Control
Sound Retriever
Setting
Sound Delay
Dual Mono
DRC
SACD Gain
LFE Attenuate
Auto delay
Digital Safety
Effect Level
2 PL II Music
Options
Neo:6 Options
All Inputs
Default
Amp
ON
ON
See also Setting the Audio options on page 69 for other default
A
DSP settings.
Normal
MCACC
SMALL
MCACC Position Memory
SMALL
Channel Level (M1–M6)
SMALL
Speaker Distance (M1–M6)
SMALLx2
Standing Wave
(M1–M6)
YES
80 Hz
EQ Data (M1–M6)
OFF
0.0–0.3m
Variable
–60 dB
OFF
OFF
OFF
ON
ON
OFF
Default
0.0 frame
CH1
OFF
0 dB
0 dB
OFF
OFF
Extended Stereo 90
Other modes 50
Center Width 3
Dimension 0
Panorama OFF
Center Image 3 (Neo:6 Music)
10 (Neo:6
Cinema)
Listening Mode AUTO
(2 ch) SURROUND
Listening Mode AUTO
(x ch) SURROUND
Listening Mode STEREO
(HP)
M1: MEMORY 1
0.0 dB
3.00 m
ATT 0.0 dB
SWch Wide Trim 0.0 dB
All channels/bands 0.0 dB
EQ Wide Trim 0.0 dB
11
73
En