Preferential Memory Scan - Yaesu FT-65R/E Operating Manual

s
Canning
1. Recall the Memory Channel to be skipped during scanning.
2. Press the F/W key, then press the [ 0 SET] key to enter the Set mode.
3. Press [▲] [▼] key to select Set Mode Item "29: SKIP"
4. Press the F/W switch momentarily to enable adjustment of this Set Mode
Item.
5. Press [▲] [▼] key so as to select "SKIP." then press F/W switch.
The current Memory Channel will now be ignored during scanning and black
color.
6. If skipped memory select then press F/W switch, will be not skip during the
memory scanning.
7 When you have made your selection, press the [PTT] switch to save the set-
ting and exit to normal operation.
To re-institute a channel into the scanning loop, select "OFF" in step 5 above (the
"Skipped" channel will, of course, still be accessible via manual channel selec-
tion methods using [▲] or [▼] key in the MR mode, whether or not it is locked
out of the scanning loop).

Preferential Memory Scan

The FT-65R/E also allows you to set up a "Preferential Scan List" of channels
which you can "flag" within the memory system. These channels are designated
by a blinking "" icon when you have selected them, one by one, for the Prefer-
ential Scan List.
Here is the procedure for setting up and using the Preferential Scan List:
1. Recall the Memory Channel which you wish to add to the Preferential Scan
List.
2. Press the F/W key, then press the [ 0 SET] key to enter the Set mode.
3. Press [▲] or [▼] key to select Set Mode Item 29: SKIP.
4. Press the F/W key momentarily to enable adjustment of this Set Mode Item.
5. Press [▲] or [▼] key so as to select "ONLY."
6. When you have made your selection, press the PTT key to save the settings
and exit to normal operation.
7. To remove a channel from the Preferential Scan List, just repeat the above
procedure, pressing [▲] or [▼] key to select "OFF" in step 5 above.
In the factory default configuration, you may recall Set Mode Item 29: SKIP
by pressing F/W  [ 8 ( P2 )] .
To initiate Preferential Memory Scan:
1. Press the F/W key, then press the [ 0 SET] key to enter the Set mode.
2. Press [▲] or [▼] key to select Set Mode Item ######.
3. Press the F/W key momentarily to enable adjustment of this Set Mode Item.
4. Press [▲] or [▼] key so as to select "ONLY."
5. Press the PTT key to save the settings and exit to normal operation.
20
Application for FCC / IC
FCC ID: K6620665X20 / IC: 511B-20665X20
FT-65R/E Operating Manual