Tuner; Direc Access Tining; Aed Bane Etd Anna Eus Rt Tas Er A Aa - Pioneer VSX-D601 Operating Instructions Manual

TUNER
Press the POWER switch to the ON position.
Select TUNER with the INPUT SELECTOR.
Be sure to turn the TAPE 2 MONITOR button OFF when listening
to AM or FM broadeasts.
Switch ON the SPEAKERS button corresponding to the speakers [
__being used.
® illustration shows model VSX-D601
[FM auto stereo reception and monaural reception
Each time you press the FM MODE AUTO/MONDO button, the FM |
MONO indicator in the display section lights or goes out. H
* if an FM stereo broadcast is received when the FM MONO
indicator is out, the STEREO indicator lights, and sound is in sterec.
«lf an FM stereo broadcast is received when the FM MONO
indicator is lit, the sound will be monaural.
if there is interference during STEREO mode reception, switch to |
FM MONO. The sound will become monaural but interference will
be reduced.
eae ES
|
DIRECT ACCESS TUNING —
1 2 3 4
When you know the frequency of the desired station, the frequency
can be input directly using the STATION CALL (number) buttons in the
following way:
1. Select either FM or AM using the BAND FM/AM button.
2. Press the DIRECT ACCESS button
3. input the desired station frequency using the STATION CALL
buttons.
DIRECT
Example: To receive FM 106.00 MHz ACCESS
(STATION CALL buttons}
As
se _
rin
Once the station frequency has been input, the receiver tunes in that
frequency. If the input frequency falls below the lower or higher limit
of the receiver's receivable frequency range "LOWER" or "UPPER" is
displayed, indicating that the frequency which has been input cannot
be tuned in,
4. Adjust the sound volume and tone as desired.
To cancel frequency input
Direct access is canceled when the DIRECT ACCESS button is pressed
again,
Under the following conditions direct access is canceled and the unit
returns to the condition in effect before direct access was selected:
() if there is no key Input for about five seconds after the DIRECT
ACCESS button was pressed.
@® If more than about eight seconds elapse between number input.
Notes regarding direct access tuning
* There is no need to input the last digit 'OQ' of the desired station
frequency.
On the multi-voitage model, it is necessary to input the last digit of
the desired station frequency when the channel step switch is set
at the 50 kHz/9 kHz position.
| AUTO TUNING
Auto tuning is convenient when you do not remember the frequency
of a desired station, or when you wish to find stations that you do not
hormally listen to
13 2 4
1. Use the BAND FM/AM button to choose either FM or AM.
20
<ARBI380 >
En
2. Press the AUTO/MANUAL button and the AUTO TUNING indicator
lights.
3. Press the +" or '"'~"' of the TUNING buttons,
° Pressing '' +" causes scanning to take place in the direction of
increasing frequency. Pressing "~'' causes scanning to take place
in the direction of decreasing frequency. : .
° When a station is received, scanning will stop (the [TU 0]
indicator lights). If you wish to receive a different station, press
the TUNING button 4 or "--" again.
® Pressing either of the TUNING (—, +) butten during auto tuning
causes tuning to stop at the current frequency.
4. Adjust the sound volume and tone as desired.
NOTE:
° When Auto Tuning is used, correct reception may not be possible
for very distant stations or stations with very weak signals. In this
event, Manual Tuning is recommended.
* The z indicator may not light with broadcasts received over
long aces, or when the broadcast signals are extremely weak.