Flash-To-Pass; Automatic Headlights - Dodge charger 2018 Owner's Manual

Hide thumbs Also See for charger 2018:
Table of Contents

Advertisement

NOTE:
• The Automatic High Beam Headlamp Control can be
turned on or off by selecting "ON" under "Auto High
Beam" within your Uconnect settings, as well as turning
the headlight switch to the AUTO position. Refer to
"Uconnect Settings" in "Multimedia" for further infor-
mation.
• Broken, muddy, or obstructed headlights and taillights
of vehicles in the field of view will cause headlights to
remain on longer (closer to the vehicle). Also, dirt, film,
and other obstructions on the windshield or camera lens
will cause the system to function improperly.
If the windshield or Automatic High Beam Headlamp
Control mirror is replaced, the mirror must be re-aimed to
ensure proper performance. See your local authorized
dealer.
To Activate
1. Turn the headlight switch to the AUTO headlight position.
2. Push the multifunction lever away from you (toward
front of vehicle) to engage the high beam mode.
NOTE: This system will not activate until the vehicle is at
or above 15 mph (24 km/h).
GETTING TO KNOW YOUR VEHICLE 67
To Deactivate
1. Pull the multifunction lever toward you (or rearward in
vehicle) to manually deactivate the system (normal
operation of low beams).
2. Push back on the multifunction lever to reactivate the
system.

Flash-To-Pass

You can signal another vehicle with your headlights by lightly
pulling the multifunction lever toward you. This will turn on
the high beam headlights until the lever is released.
NOTE: If the multifunction lever is held in the flash-to pass
position for more than 20 seconds, the high beams will shut
off.

Automatic Headlights

This system automatically turns the headlights on or off
according to ambient light levels. To turn the system on,
rotate the headlight switch counterclockwise to the AUTO
position. When the system is on, the headlight time delay
feature is also on. This means the headlights will stay on
for up to 90 seconds after you place the ignition into the
OFF position. The headlight time delay can be pro-
grammed 0/30/60/90 seconds.
3

Advertisement

Table of Contents
loading

Table of Contents