Dodge charger 2018 Owner's Manual page 51

3. Push and release the set (S) button on the memory
switch.
4. Within five seconds, push and release either of the
memory buttons (1) or (2). The instrument cluster dis-
play will display which memory position has been set.
NOTE:
• Memory profiles can be set without the vehicle in PARK,
but the vehicle must be in PARK to recall a memory
profile.
• To set a memory profile to your key fob, refer to
"Linking And Unlinking The Remote Keyless Entry Key
Fob To Memory" in this section.
Linking And Unlinking The Remote Keyless Entry
Key Fob To Memory
Your key fobs can be programmed to recall one of two
pre-programmed memory profiles by pushing the unlock
button on the key fob.
NOTE: Before programming your key fobs you must select
the "Personal Settings Linked To Fob" feature through the
Uconnect system screen. Refer to "Uconnect Settings" in
"Multimedia" for further information.
GETTING TO KNOW YOUR VEHICLE 49
To program your key fobs, perform the following:
1. Place the vehicle's ignition to the OFF position.
2. Select desired memory profile (1) or (2). The system will
recall any stored settings for this profile. Wait for the
system to complete the memory recall before continuing
to step three.
NOTE: If a memory profile has not already been set, refer
to Programming The Memory Feature in this section for
instructions on how to set a memory profile.
3. Once the profile has been recalled, push and release the
set (S) button on the memory switch, then push and
release memory button (1) or memory button (2) accord-
ingly. "Memory Profile Set" (1 or 2) will display in the
instrument cluster display.
4. Push and release the lock button on the key fob within
10 seconds.
NOTE: Your key fobs can be unlinked from your memory
settings by pushing the set (S) button, and within 10
seconds push the unlock button on the key fob.
3