Installation Procedure - Toshiba RAS-07BKVG-E Service Manual

10-1. Installation Diagram of Indoor and Outdoor Units
3
Batteries
2
Wireless remote control
RAS-05, 07, 10, 13BAVG-E
C 600
D 400
E 45
F 100
Remark :
• Detail of accessory and installation parts can see in the
accessory sheet.
• Some pictures might be different from the actual parts.
• Loading Batteries
1. Remove the battery cover.
2. Insert 2 new batteries (AAA type)
following the (+) and (-) positions.
AMP Air Conditioning

10. INSTALLATION PROCEDURE

Refrigerant piping
must be protected from
physical damage.
Install a plastic cover or
equivalent.
6
Flat head
wood screw
4
Remote control
holder
RAS-16BAVG-E
600
600
100
100
Before installing the wireless remote controller
2 Wireless remote controller
Hook
1 Installation
plate
Shield pipe
Vinyl tape
Apply after carrying
out a drainage test.
Saddle
Extension drain hose
(Not available, provided
by installer)
- 55 -
www.ampair.co.uk | sales@ampair.co.uk
FILE NO. SVM-16030
For the rear left and left piping
Wall
Insert the cushion between the indoor
unit and wall, and tilt the indoor unit for
better operation.
The auxiliary piping can be connected to
the left, rear left, rear right, right, bottom
right or bottom left.
Right
Rear
right
Bottom Rear
right left
Bottom left
Do not allow the drain hose to get slack.
Cut the piping
hole sloped
slightly.
Make sure to run the drain hose sloped
downward.
The are connection should be installed
outdoors.
Insulate the refrigerant pipes separately
with insulation, not together.
6 mm thick heat resisting
polyethylene foam
3 Batteries
Left