Table of Contents
Advertisement
Additional information
13
USB interface
Symptom
USB mass storage device is not
recognized by the receiver.
USB ERR3 shows in the display
when connecting a USB device.
Can't play audio files.
HDMI
Symptom
No picture or sound.
No picture.
OSD does not appear.
No sound, or sound suddenly
ceases.
Note
• If the unit does not operate normally due to external effects such as static electricity disconnect the power plug
from the outlet and insert again to return to normal operating conditions.
64
En
Remedy
• Try switching the receiver off, then on again.
• Make sure you have completely inserted the USB connector to this receiver.
• Check that the memory format is FAT16 or FAT32 (FAT12, NTFS and HFS are not supported).
• USB devices with an internal USB hub are not supported.
• If this message continues to appear after going through all the checks in Important on page 31 of USB
playback, take the unit to your nearest Pioneer authorized service center or your dealer for servicing.
• The WMA or MPEG-4 AAC files were recorded using DRM (digital rights management), or the bit rate/
sampling rate is not compatible (see Compressed audio compatibility on page 31). This is not a
malfunction.
Remedy
• If the problem still persists when connecting your HDMI component directly to your monitor, please
consult the component or monitor manual or contact the manufacturer for support.
• Depending in the output settings of the source component, it may be outputting a video format that can't
be displayed. Change the output settings of the source, or connect using the component, S-video or
composite jacks.
• The OSD will not appear if you have connected using the HDMI output to your TV. Use component, S-
video, or composite connections when setting up the system.
• Since the HDMI audio signal is sent through this receiver to your TV, you need to make separate
connections for audio if you want to hear your HDMI component through this system. See Connecting using
HDMI on page 44 for more on this.
• If you've made separate connections for audio, make sure you have assigned the analog/digital jack(s) to
the corresponding HDMI input for the component. See Assigning the HDMI inputs on page 50 to do this.
• Check the audio output settings of the source component.
Advertisement
Table of Contents
