Table of Contents
Advertisement
The System Setup menu
08
4
Adjust the level of each channel using
If you selected Manual, use
Auto setup will output test tones in the order shown on-
screen:
Adjust the level of each speaker as the test tone is
1
emitted.
5
When you're finished, press RETURN.
You return to the Manual SP Setup menu.
Tip
• You can change the channel levels at any time by
using EFFECT/CH SEL and +/– on the remote control.
You can set two channel levels: one for MULTI CH IN
and one for the listening modes.
Speaker Distance
For good sound depth and separation from your system,
you need to specify the distance of your speakers from
the listening position. The receiver can then add the
proper delay needed for effective surround sound.
1
Select 'Speaker Distance' from the Manual SP
Setup menu.
4.Manual SP Setup
a.Speaker Setting
b.Crossover Network
c.Channel Level
d.Speaker Distance
e.THX Audio Setting
f.THX Speaker Setup
2
Adjust the distance of each speaker using
You can adjust the distance of each speaker in 0.1 meter
increments.
3
When you're finished, press RETURN.
You return to the Manual SP Setup menu.
Tip
• For best surround sound, make sure the surround
back speakers are the same distance from the
listening position.
Note
1 • If you are using a Sound Pressure Level (SPL) meter, take the readings from your main listening position and adjust the level of each speaker to 75 dB
SPL (C-weighting/slow reading).
• The subwoofer test tone is output at low volumes. You may need to adjust the level after testing with an actual soundtrack.
2 If you don't have surround back speakers, or just have one, you won't be able to select this setting (Cannot select shows in the display).
42
En
to switch speakers. The
4c.Channel Level
L
0.0dB
C
[
0.0dB ]
R
[
0.0dB ]
SR
[
0.0dB ]
SBR
[
0.0dB ]
SBL
[
0.0dB ]
SL
[
0.0dB ]
SW
[
0.0dB ]
:Finish
4d.Speaker Distance
L
3.0 m
C
[ 3.0 m ]
R
[ 3.0 m ]
SR
[ 3.0 m ]
SBR
[ 3.0 m ]
SBL
[ 3.0 m ]
SL
[ 3.0 m ]
SW
[ 3.0 m ]
:Finish
:Return
THX Audio Setting
.
For the most effective results when using the THX Select2
Cinema and THX MusicMode listening modes (see Using
the Home THX modes on page 27) with the Advanced
Speaker Array (ASA) system (see About THX on page 66),
it is required that you make the setting. See THX speaker
system setup on page 19 for more on THX speaker
2
placement.
1
Select 'THX Audio Setting' from the Manual SP
Setup menu.
2
Specify the distance of your surround back speakers
from each other.
• 0.0 – 0.3m – Surround speakers within 30 cm apart
(best for THX surround sound).
• > 0.3 – 1.2m – Surround speakers between 30 cm
and 1.2 m apart.
• 1.2m < – Surround speakers more than 1.2 m apart.
3
When you're finished, press RETURN.
You will return to the Manual SP Setup menu.
.
4.Manual SP Setup
a.Speaker Setting
b.Crossover Network
c.Channel Level
d.Speaker Distance
e.THX Audio Setting
f.THX Speaker Setup
:Return
4e.THX Audio Setting
SB SP Position
0.0-0.3m
SBL-SBR
:Finish
Advertisement
Table of Contents
