Table of Contents
Advertisement
Section
03
Operating this unit
6
Touch b and then touch c or d to se-
lect the desired Q factor.
Touch c or d until the desired Q factor ap-
pears in the display.
2W—1W—1N—2N
Note
If you make adjustments, CUSTOM curve is up-
dated.
Adjusting bass and treble
You can adjust bass and treble settings.
! If EQ-EX function has been selected and
only when EQ-EX is turned on and
CUSTOM is selected as the equalizer
curve, you can adjust bass and treble set-
tings. (Refer to Compensating for equalizer
curves (EQ-EX) on page 34.)
Adjusting bass
You can adjust the cut-off frequency and the
bass level.
1
Touch BASS on the audio function
menu.
2
Touch a or b to adjust the bass level.
Each time you touch a or b increases or de-
creases the bass level. +6 to –6 is displayed as
the level is increased or decreased.
3
Touch c or d to select the desired fre-
quency.
Touch c or d until the desired frequency ap-
pears in the display.
40Hz—63Hz—100Hz—160Hz
Adjusting treble
You can adjust the cut-off frequency and the
treble level.
32
En
1
Touch TREBLE on the audio function
menu.
2
Touch a or b to adjust the treble level.
Each time you touch a or b increases or de-
creases the treble level. +6 to –6 is displayed
as the level is increased or decreased.
3
Touch c or d to select the desired fre-
quency.
Touch c or d until the desired frequency ap-
pears in the display.
2.5kHz—4kHz—6.3kHz—10kHz
Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1
Touch LOUDNESS (LOUD) on the audio
function menu.
2
Touch a to turn loudness on.
# To turn loudness off, touch b.
3
Touch c or d to select a desired level.
Each time you touch c or d selects level in
the following order:
LOW (low)—MID (mid)—HIGH (high)
Using subwoofer output
This unit is equipped with a subwoofer output
which can be turned on or off.
! When the subwoofer output is on, you can
adjust the cut-off frequency and the output
level of the subwoofer.
1
Touch SUB WOOFER on the audio func-
tion menu.
# When the subwoofer controller setting is
FULL, you cannot select SUB WOOFER.
Advertisement
Table of Contents
