Adjusting Loudness; Using The Subwoofer Output; Enhancing Bass (Bass Booster); Using The High Pass Filter - Pioneer SPH-DA100 Operation Manual

Customising preferences

Adjusting loudness

Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Display the "Audio" screen.
➲ For details, refer to Customising the audio
settings on page 35.
2 Tap or next to "Loudness".
Each time you tap or
in the following order:
Off (default) — Low —

Using the subwoofer output

This product is equipped with a subwoofer
output that can be turned on or off.
❐ The cut-off frequency and output level can
be adjusted when the subwoofer output is
on.
1 Display the "Audio" screen.
➲ For details, refer to Customising the audio
settings on page 35.
2 Tap [Subwoofer].
The " Subwoofer " screen appears.
3 Tap [Subwoofer] to set to "On".
The subwoofer output is turned on.
If you select " Off ", the subwoofer output is
■
turned off.
4 Tap [Phase] to select "Normal" or
"Reverse" to set the phase of subwoofer
output.
the level is selected
,
Mid — High
5 Tap or next to "Level" to adjust
the output level.
" +6 " to " –4 " is displayed as the level is in-
creased or decreased.
6 Tap or next to "Frequency" to se-
lect cut-off frequency.
Each time you tap or
are selected in the following order:
50Hz — 63Hz — 80Hz (default)
Only frequencies lower than those in the se-
lected range are output from the subwoofer.

Enhancing bass (Bass Booster)

You can enhance bass sounds that are often
muted by driving noise.
1 Display the "Audio" screen.
➲ For details, refer to Customising the audio
settings on page 35.
2 Tap or next to "Bass Booster" to
adjust the range from 0 to +6.

Using the high pass filter

When you cut lower sounds from the subwoof-
er output frequency, activate "
ter ". Only frequencies higher than those in the
selected range are output from the front or
rear speakers.
1 Display the "Audio" screen.
➲ For details, refer to Customising the audio
settings on page 35.
2 Tap or next to "High Pass Filter".
Each time you tap
are selected in the following order:
Off (default) — 50Hz —
— 15Hz
, cut-off frequencies
— 100Hz — 15Hz
High Pass Fil-
or cut-off frequencies
,
63Hz — 80Hz — 100Hz
Engb
Chapter
08
37