Pioneer YPM-MG2196ZF Service Manual page 46

YPM-MG2196ZF
7. Loosen the 2 screws (D). Remove the Gear cover.
8. Loosen the 3 screws (E). Remove the Motor bracket
assy.
9. Remove the 5 polyslider washers, then gears and
shaft.
10. Loosen the 4 screws. Remove the Cam gear motor
and ELV motor.
- How to remove the Loading motor
1. Insert a short pin into the flexible PCB of the Pickup
unit.(See Fig. 3)
Remove the Cover from the Side PCB. (See Fig. 3)
Disconnect the flexible PCBs from the connectors
CN863 and CN864. (See Fig. 3)
Disconnect the the flexible PCB (Motor PCB (A)) from
the connector CN862 on the Side PCB. (See Fig. 9)
Loosen the 2 screws (A). Remove the Side PCB.
2. Unhook the spring. Remove the Door open lever.
3. Loosen the 3 screws. Remove the Photo(L) PCB,
PCB unit(C) and the frame.
4. Remove the spring (A).
46
Motor bracket
assy
Cam gear motor
ELV
motor
Shaft
Black White
Photo(L) PCB
PCB unit(C)
Frame
Front
Gear cover
Fig. 10
Apply grease (White:EM-
50L) to the Shaft and
gears.
Spring
Door open lever
Black
Fig. 12
Fig. 11