I40 Speed Operation - Raymarine i40 Installation And Operation Instructions Manual

4. With the Deep alarm page displayed:
i. Press the Up button to display the Shallow alarm page, or
ii. Press the Down button to display the Shallow anchor alarm
page, or
iii. Press and hold the Up button for 3 seconds to switch the
deep alarm on and off.
5. With the Shallow anchor alarm page displayed:
i. Press the Up button to display the Deep alarm page, or
ii. Press the Down button to display the Deep anchor alarm
page, or
iii. Press and hold the Up button to switch the shallow anchor
alarm on and off.
6. With the Deep anchor alarm page displayed:
i. Press the Up button to display the Shallow anchor alarm
page, or
ii. Press the Down button to display the Depth offset page, or
iii. Press and hold the Up button to switch the deep anchor
alarm on and off.
7. With the Depth offset page displayed:
i. Press the Up button to display the Deep anchor alarm page,
or
ii. Press the Down button to display the Current depth page.
Note: Only the Current depth page is a permanent page, all
other pages will time out after 5 seconds and revert back to the
last permanent page displayed.
Using your display

7.4 i40 Speed operation

When connected to the relevant speed or speed and temperature
transducer, your i40 Speed instrument provides:
• Current, maximum and average speed information, in either knots
(KTS), mile per hour (MPH) or kilometers per hour (KPH).
• Log and trip information, in either nautical miles (NM), statute
miles (M) or kilometers (KM).
• Water temperature information, in either degrees celsius (ºC) or
fahrenheit (ºF).
Note: The required speed, distance and temperature units are
selected during User calibration.
It should be noted that:
• The maximum speed, average speed and trip reading are reset to
zero at power up.
• The log screen shows the total distance covered by the vessel
since the unit was fitted.
Using the speed pages
1
60 5
55
3 10
50
45 15
40 20
35 25
30
2
60 5
55
50 3 10
45 15
40 20
35 25
30
3
Note: The trip distance reading can only be reset if the unit's
status is set to Master (See the Data master section for details).
1. With the Current speed page displayed:
i. Press the Up button to display the Water temperature page,
or
ii. Press the Down button to display the Maximum speed page.
2. With the Maximum speed page displayed:
i. Press the Up button to display the Current speed page, or
ii. Press the Down button to display the Average speed page,
or
iii. Press and hold the Up button for 3 seconds to reset the
maximum speed reading.
3. With the Average speed page displayed:
i. Press the Up button to display the Maximum speed page, or
ii. Press the Down button to display the Log page, or
iii. Press and hold the Up button for 3 seconds to reset the
average speed reading.
4. With the Log page displayed.
i. Press the Up button to display the Average speed page, or
ii. Press the Down button to display the Trip page.
5. With the Trip page displayed:
i. Press the Up button to display the Log page, or
ii. Press the Down button to display the Current water
temperature page, or
6
60 5
55
3 10
50
45 15
40 20
35 25
30
5
4
D12511-1
39