General Operation - Raymarine ST60+ Quick Start Manual

General operation

+
GRAPHIC
RESET
TRACK
TRACK
Gives access to track
Selects the required
mode. In track mode you
PAGE.
can:
- Hold down for 1 second
to advance to the next
waypoint.
- Press to leave track
mode.
When an adjustable
value is displayed, press
to decrease the value.
RESET
When resettable data are
Selects the required CHAPTER. displayed, hold down for 3
seconds to reset the data to
Also gives access to backlight
the current value.
adjust, contrast adjust and
power on/off modes (see
When an adjustable value is
overleaf).
displayed, press to increase
the value.
Selecting chapters & pages
SPEED
WIND
Speed Apparent wind speed
Maximum speed Apparent wind angle
Average speed True wind speed
SOG
True wind angle (sail)
SOG
True wind dir. over ground
Speed
Beaufort wind force
VMG Windward
Cardinal wind direction
Log
Apparent wind speed graph
Trip log
Apparent wind angle graph
Timer
True wind speed graph
Speed graph
True wind angle graph
Ground wind angle graph
To select a chapter
DEPTH
Current depth
Minimum depth
HEADING
Maximum depth
Current heading
momentary
press, to step
Depth graph
Locked heading
forward
Tack heading
COG
FAVORITE
COG
Favorite page 1
Heading
1 sec press, to
Favorite page 2
CMG
step back
DMG
Favorite page 3
Heading graph
Favorite page 4
Favorite page 5
Favorite page 6
To select a page
Favorite page 7
NAVIGATE
BTW (bearing to waypoint)
DTW (distance to waypoint)
AUTOPILOT
momentary
XTE (cross track error)
Note: AUTOPILOT
press, to step
Waypoint number
chapter available only
forward
Waypoint name
if a Raymarine
autopilot system is
LAT(itude)
connected to SeaTalk
LON(gitude)
Pilot status
COG (course over ground)
Rudder angle
SOG (speed over ground)
1 sec press, to
COG (course over ground)
step back
BTW (bearing to waypoint)
SATS
ENVIRONMENT
HDOP
Sea temperature
COG
Heading
Battery voltage
SOG
Time
Speed
Date
Rolling road
Sea temperature graph
Battery voltage graph VMG to waypoint
Seting up Favorite pages
1. Select required Favorite page
1
+
2. Enter Favorite set up
2 seconds
TRACK RESET
3. Select the required
page format
RESET
Single element
Quad
element
RESET
Triple element
4. Highlight the line you want to set up
TRACK TRACK
TRACK
5. Select the required data in the highlighted line
MXD 7.5 MND 7.5 RUD 10
FA FA
RESET
Dual
element
RESET
o
DATE 3/3/03