Table of Contents
Advertisement
Complete the following steps to install a power supply:
1. (Some models) Remove the power-supply blank from the empty power-supply
bay by pinching the side clip and pulling the power-supply blank from the bay.
Save the power-supply blank in case you remove the power supply at a later
time.
Attention:
During normal operation, each power-supply bay must have either
a power supply or power-supply blank installed for proper cooling.
2. Install the power supply in the bay:
a. Move the handle on the power supply into the open position, pinch the
side-clip, and slide the power supply into the chassis.
b. Gently close the handle to seat the power supply in the bay.
3. Plug the power cord for the new power supply into the power-cord connector on
the back of the server.
The following illustration shows the power-supply connectors on the back of the
server.
4. Route the power cord through the cable-management arm. (See "Installing the
server in a rack" on page 35).
5. Plug the power cord into a properly grounded electrical outlet.
6. Verify that the dc power LED and ac power LED on the power supply are lit,
indicating that the power supply is operating correctly.
Power supply 1
power cord connector
Power supply 2
power cord connector
Chapter 2. Installing options
29
Advertisement
Table of Contents
