Table of Contents
Advertisement
Install the DIMMs in the order shown in the following table:
The following illustration shows how to install DIMMs on the system board.
Before you begin, read the documentation that comes with your option.
Complete the following steps to install a DIMM.
1. Review the information in "Safety" on page v, and "Installation guidelines" on
2. Turn off the server and disconnect all power cords and external cables (see
3. Locate the DIMM connectors on the system board. Determine the connectors
4. Touch the static-protective package that contains the DIMM option to any
5. To install the DIMM, repeat the following steps for each DIMM that you install:
22
IBM xSeries 345 Type 8670: Option Installation Guide
Table 2. DIMM order of installation
Pair
First
Second
DIMM 3 (J3)
DIMM 4 (J4)
page 9.
"Turning off the server" on page 12); then, remove the server cover (see
"Removing the cover and bezel" on page 13).
into which you will install the DIMMs.
unpainted metal surface on the server. Then, remove the DIMM from the
package.
a. Turn the DIMM so that the DIMM keys align correctly with the connector on
the system board.
Attention:
To avoid breaking the retaining clips or damaging the DIMM
connectors, handle the clips gently.
b. If closed, open the retaining clips; then, insert the DIMM by pressing the
DIMM straight into the connector. Be sure that the retaining clips snap into
the closed position.
DIMM connectors
1 and 2 (J1, J2)
3 and 4 (J3, J4)
DIMM 1 (J1)
DIMM 2 (J2)
Advertisement
Table of Contents
