Siemens SIMATIC Ident System Manual page 51

RF350T
RF360T
All values are in mm
Table 4- 8
RF320T
RF330T
RF340T
RF350T
RF360T
RF370T
RF380T
All values are in mm
The RF380R with MLFB 6GT2801-3AB10 allows the transmission output power to be set
with the aid of the "distance_limiting" input parameter (you will find more detailed information
in "Function manual FB 45
(https://support.industry.siemens.com/cs/ww/en/view/21738808)"). For this, values from
approx. 0.5 W to approx. 2.0 W can be set in 0.25 W increments. Depending on the setting,
the change to the transmission output power increases the performance in the lower
operating distance (low performance) or in the upper limit distance (high performance).
The "distance_limiting" range of values is from:
● 02 (= 0.5 W) through
● 05 (= 1.25 W; default value) to
● 08 (= 2 W).
Note
A 'distance_limiting' value setting outside of the range of "02 to 08" leads to the default
setting 5 and does not generate an error message.
You will find more information on this subject in the chapter "Minimum clearances (Page 59)"
section "Minimum distance from reader to reader".
You will find precise information about the parameters in "Product Information "FB 45 and
FC 45 input parameters for RF300 and ISO transponders"
(https://support.industry.siemens.com/cs/ww/en/view/33315697)".
SIMATIC RF300
System Manual, 07/2016, C79000-G8976-C345-0x
Diameter of the transmis-
sion window (L )
d
25
??
Field data RF380R reader
Length of the transmission window
in the x direction (L ) in the y direction (L
x
100
120
120
140
160
160
180
4.2 Field data for transponders, readers and antennas
Operating distance (S
a
0...35
2...25
Operating distance
(S
)
y
40 2...45
30 5...45
50 2...80
60 2...100
70 2...120
65 5...100
75 5...125
Planning the RF300 system
) Limit distance (S
40
35
Limit distance (S
)
a
60
52
105
125
150
135
160
)
g
)
g
51