Useful Adjustment Settings; Switching The Vertical Drive Frequency; Adjusting Image Positions (Av Mode Only); Adjusting Image Positions And Clock Automatically (Pc Mode Only) - Pioneer PureVision PDP-427XG Operating Instructions Manual

Useful adjustment settings

Chapter 9
Useful adjustment settings

Switching the vertical drive frequency

You can switch the vertical drive frequency for screen display
between 75 Hz and 100 Hz. Choose the drive frequency that best
suits the broadcast signals in your area.
1 Press HOME MENU.
2 Select "Option" ( then ENTER).
3 Select "Drive Mode" (
4 Select "75 Hz" or "100 Hz" (
Drive Mode
75Hz
100Hz
5 Press HOME MENU to exit the menu.
Note
• This setting can be made for each input source separately.
• Selections are effective only for the following input signals:
PAL/SECAM, 576i, 576p, 1080i@50 Hz, 720p@50 Hz.
• This setting cannot be made when 480i, 480p, 1080i@60 Hz,
720p@60 Hz, or 1080p@24 Hz signals are input.
• If you select "Auto" for "Side Mask" (page 37), the selection for
"Drive Mode" becomes ineffective.

Adjusting image positions (AV mode only)

Adjust the horizontal and vertical positions of images on the
plasma display.
1 Press HOME MENU.
2 Select "Option" ( then ENTER).
3 Select "Position" ( then ENTER).
4 Select "H/V Position Adjust" (
Position
H/V Position Adjust
Reset
5 Adjust the vertical position (
position ( ).
6 Press HOME MENU to exit the menu.
Note
• To restore the factory defaults for all items, press
"Reset" in step 4, and then press ENTER. A confirmation screen
to select "Yes", and then press ENTER.
appears. Press
• Adjustments are stored separately according to input source.
then ENTER).
then ENTER).
then ENTER).
) or the horizontal
to select
• Depending on the displayed video, the image position may not
change even after adjustment.
Adjusting image positions and clock
automatically (PC mode only)
Use Auto Setup to automatically adjust the positions and clock of
images coming from a personal computer.
1 Press HOME MENU.
2 Select "Option" ( then ENTER).
3 Select "Auto Setup" (
Option
Auto Setup
Manual Setup
• Auto Setup starts.
4 Press HOME MENU to exit the menu.
Note
• When Auto Setup is finished, "Auto Setup completed." appears.
• Even when "Auto Setup completed." appears, Auto Setup may
have failed, depending on conditions.
• Auto Setup may fail with a PC image composed of similar
patterns or monochrome. If not successful, change the PC
image and try again.
• Be sure to connect the computer to the plasma display and
switch it on before starting Auto Setup.
Adjusting image positions and clock
manually (PC mode only)
Usually you can easily adjust the positions and clock of images
using Auto Setup. Use Manual Setup to optimize the positions and
clock of images when necessary.
1 Press HOME MENU.
2 Select "Option" ( then ENTER).
3 Select "Manual Setup" (
4 Select the item to be adjusted (
Manual Setup
H/V Position Adjust
Clock
Phase
Reset
5 Perform adjustment (
• With "Clock" or "Phase" selected, you can change the
parameter using .
then ENTER).
then ENTER).
then ENTER).
0
0
).
09
35
En