Share Waypoints - Humminbird 700 Series Installation & Operation Manual

Share Waypoints

To share waypoints on the network, turn on Share Waypoints on each control
head. You can then observe the following:
• When a waypoint is marked on one control head, the waypoint will
also be displayed on the other control head. If the waypoint is saved, it
will be saved to the local control head where it was marked.
• Routes: When waypoints are viewed on both control heads, you can
build a route from either control head using the shared waypoints. The
route is saved to the control head where it was created.
NOTE: When the units are powered off, the waypoint data is saved only on its local
control head where it was originally marked. Routes and tracks are not shared on the
network.
NOTE: Although the navigation data is viewable, it is not copied on every control
head. In other words, a new route will be saved to the control head where the
route was initiated. If you edit navigation data, the data will be saved back to its
local control head.
Share Waypoints
1. Main Menu: Press the MENU key twice. Select the Network tab.
2. Select Share Waypoints. Press the RIGHT Cursor key to select On. (On,
Off; Default = Off).
3. Repeat steps 1 - 2 on each control head so that each control head is
sharing (or broadcasting) its waypoint data on the network.
NOTE: The remaining navigation menu options are controlled locally. The Shared and
Local menu options may change to accommodate new product features.
27
Share Waypoints