b. On the Chroma Board screen, verify that the FPD Temp Zone is the same as that specified in
the Data Package (see Figure 2-10).
c. On the Chroma Board screen, observe the "Ignitor" line. "Manual" should be underlined.
d. Press the F1 (Exit) soft key.
e. On the Manual Control Mode Screen, press the F4 (Press. & Temp. Control) soft key.
f.
On the Pres and Temp Control screen, cursor to TEMP CONTROL and press the F2 (Manual
Temp Control) soft key.
2-18
*****
Chroma Board
Detector:
FPD
Flame:
Lit
Ignitor:
Hardware Zero:
Software Zero:
Detector Reading:
Ignitor:
Manual
Timeout:
0
seconds
FPD Temp Zone: 0
Exit
Graphics
F1
F2
Figure 2-10. CHROMA BOARD SCREEN
Off
H2:
5.10mV
(
-
3.18mV
1.98mV
Auto
Auto Timeout
Manually
Zero
Baseline
F3
*****
None
4.7%)
Manual
Ignitor
On
F4
2000-OSM, F1