Recording From A Dv Camcorder - Pioneer DVR-530H-S Operating Instructions Manual

Recording

Recording from a DV camcorder

VR mode Video mode HDD
You can record from a DV camcorder connected to the
DV IN jack on the front panel of this recorder. Using the
recorder's remote, you can control both the camcorder
and this recorder.
Before recording, make sure that the audio input for the
DV IN jack is setup (see DV Input on page 94).
HDD
AUDIO
HOME
MENU
REV SCAN
PAUSE STOP
Important
• The source signal must be DVC-SD format
• Some camcorders cannot be controlled using this
recorder's remote.
• If you connect a second recorder using a DV cable,
you cannot control the second unit from this one.
• You can't control this unit remotely from a
component connected to the DV IN jack.
• You can't record date and time information from DV
cassette.
• During DV recording, if a part of the tape is blank, or
has copy-protected material on it, this recorder will
pause recording. Recording will restart automatically
when there is a recordable signal. However, if there is
more than 10 seconds of blank tape, this recorder will
stop recording and the camcorder should stop
(depending on the camcorder).
DVD
CLEAR
ENTER
RETURN
PLAY FWD SCAN
STEP/SLOW
REC MODE
• For best results when recording from a DV
camcorder to this recorder, we recommend cueing
the camcorder to the place you want to start
recording from and setting the camcorder to play-
pause.
1 Make sure your digital camcorder is connected to
the front panel DV IN jack.
Also, set the camcorder to VTR mode.
2 Set up the recorder.
• Use REC MODE to set the recording quality. See
Setting the picture quality/recording time on page 37
for detailed information.
• Make sure a recordable disc is loaded if you want to
record to DVD.
3 From the Initial Settings menu, check that the DV
audio input is setup as you require.
See DV Input on page 94 for more on this.
• Check also that the Audio In settings for External
Audio and Bilingual Recording are as you want
them (see Audio In Settings on page 93).
4 Press HOME MENU, select 'Copy', then 'DV
Record' from the menu.
• DV recording only works when the digital camcorder
is in VTR mode with a tape loaded.
5 Select 'Record to Hard Disk Drive' or 'Record to
DVD' to record to the hard disk drive or a recordable
DVD respectively.
6 Find the place on the camcorder tape that you
want to start recording from.
For best results, pause playback at the point from which
you want to record.
• Depending on your camcorder, you can use this
recorder's remote to control the camcorder using the
, , , , ,
7 Use the buttons to select 'Start Rec' and
press ENTER.
Stop Stop
1.02.22 1.02.22
Control with these Control with these
buttons buttons
• Recording is automatically paused if the recorder
detects no signal, or a copy-protected signal.
Recording restarts when there is a non-copy-
protected signal.
and buttons.
Stop Stop
Start Rec Start Rec
Pause Rec Pause Rec
Stop Rec Stop Rec
DVD HDD
SP (2h00m/DVD) SP (2h00m)
Rem. Rem. 32h45m 1h59m
05
47
En