Connecting An External Decoder Box (2) - Pioneer DVR-320 Operating Instructions Manual

02 Connecting up

Connecting an external decoder box (2)

If you only have a decoder, connect it to this recorder and your TV as shown on this page.
Using the setup on this page you can:
• Record scrambled channels received using the recorder's built-in TV tuner.
Important
• Do not connect this recorder 'through' your VCR, satellite receiver or cable box. Always connect each component
directly to your TV or AV amplifier/receiver.
ANTENNA
IN
SCART AV
1 2
CONNECTOR
ANTENNA
OUT IN
R L
AUDIO
VIDEO
S-VIDEO
OUTPUT
1
Antenna/cable TV
wall outlet
18
En
TV
IN OPTICAL
AV 2/AUTO START REC
AV 1 (RGB) - TV
CONTROL DIGITAL OUT
(INPUT 1/DECODER)
3
SCART AV
CONNECTOR
Decoder
1 Connect RF antenna cables as shown.
This enables you to watch and record TV channels.
2 Use a SCART cable (not supplied) to connect the
AV1(RGB)-TV AV connector to a SCART AV connector
on your TV.
This enables you to watch discs.
3 Use another SCART cable to connect the AV2/
AUTO START REC (INPUT 1/DECODER) AV connector
to a SCART AV connector on your decoder box.
This enables you to record scrambled TV channels.
AC IN
Note
• In order to use this setup, you will need to make the
following settings from the Initial Setup menu:
– Set the AV2/L1 In setting to Decoder from the
Initial Setup menu (see AV2/L1 In on page 82).
– From the Manual CH Setting screen, set the
Decoder setting for the scrambled channels to On
(see Manual CH Setting on page 80).