JVC RX-8010RBK Service Manual page 5

Removing the audio board
Prior to performing the following procedure, remove
the top cover and the rear panel.
1. Disconnect the harness from connector CN813 and
CN814 on the main board.
2. Disconnect the card wire from connector CN931 and
CN932 on the audio board.
3. Cut off the tie band fixing the harness.
4. Disconnect the relay board from the audio board and
the power supply board. (CN71,CN81)
5. Disconnect the card wire from connector CN831 on
the main board.
6. Remove the three screws G
board assembly.
7. Remove the screw H
assembly.
(See Fig.12 and 13)
attaching the audio
attaching the audio board
Video audio
board
Fig.10
Fig.11
CN814 CN813
Main
board
Audio board
CN931/ 932
Fig.12
CN831
G
G
Fig.13
RX-8010RBK/ RX-8012RSL
S Video
board
Video
board
DSP board
CN601
Relay board
CN71
power
supply
board
Tie band
Power
transformer
CN81
Power / Fuse
board
H
1-5