JVC RX-8010RBK Service Manual page 3

Disassembly method
Removing the top cover (See Fig.1)
1. Remove the four screws A attaching the top cover
on both sides of the body.
2. Remove the three screws B on the back of the body.
3. Remove the top cover from behind in the direction of
the arrow while pulling both sides outward.
Removing the front panel assembly
Prior to performing the following procedure, remove
the top cover.
1. Disconnect the card wire from connector CN400 on
the audio board and CN402 on the power supply
board in the front panel assembly.
2. Cut off the tie band fixing the harness.
3. Remove the three screws C
panel assembly.
4. Remove the four screws D attaching the front panel
assembly on the bottom of the body. Detach the front
panel assembly toward the front.
Removing the rear panel (See Fig.4)
Prior to performing the following procedure, remove
the top cover.
1. Remove the power cord stopper from the rear panel
by moving it in the direction of the arrow.
2. Remove the thirty one screws E attaching the each
boards to the rear panel on the back of the body.
3. Remove the three screws F attaching the rear panel
on the back of the body.
(See Fig.2 and 3)
attaching the front
Top cover
A
2
A
2
Tie band
Main
board
CN400
Audio board
Fig.2
D
Fig.3
E E
E
F
F
Rear panel
Fig.4
RX-8010RBK/ RX-8012RSL
B
Fig.1
Front panel assembly
C
C
CN402
Power
supply
board
Front panel assembly
D
E Cord stopper
F
E
1-3