Pioneer DVR-310 Operating Instructions Manual page 38

Recording
05
• The amount of free space available and the currently
loaded recordable DVD is shown towards the bottom
of the screen.
• In the upper-right corner, the number of timer
programs already set is shown next to Tmr Pgms.
• If there are more than five timer programs already
set, press NEXT
the PREV
• You can also delete a timer program before it's
started (before the recorder enters timer recording
standby) by highlighting it and pressing CLEAR. See
also Deleting a timer program on page 39.
2 Select 'New Input' to set a new timer program,
then press ENTER.
Timer Program Set
Manhattan Open Tennis
CH Date
Pr 10
SAT 26/3
Detailed Settings
Recording Mode
Bilingual Recording
3 Enter the timer recording settings.
Use the buttons to select a field; use the
buttons to change the value.
• CH – Choose a channel (Pr 1–Pr 99, excluding skip
channels), or one of the external inputs from which to
record.
• Date – Choose a date up to one month in advance, or
select a daily or weekly program.
• Start – Set the recording start time.
• Stop – Set the recording end time.
4 If you want to change the recording mode, etc.,
select 'Set Detailed'.
In this area you can set:
Recording Mode – Select XP, SP, LP, EP, SLP or SEP,
(See Setting the picture quality/recording time on
page 33). If Manual Recording is on, then you can also
select the LPCM setting, or MN (press ENTER then use
the buttons to select the level).
Bilingual – Select which channel of a bilingual broadcast
to record (necessary if recording to a Video mode DVD).
5 After entering all the timer recording
information, highlight 'Store Program' and press
ENTER.
The timer recording list screen is displayed again. The
timer program you just input appears in the list. The
rightmost column shows various timer recording status
messages:
• OK – Can be recorded.
38
En
to switch page (go back using
button).
Start Stop Extend
18:00 19:00 30 min
Store Program
Enter Details
XP
A/L
Set Detailed
Set Title Name
Cancel
• Time Over – Not enough space (the recording won't
finish).
• Overlap – Two timer programs partially or
completely overlap. The one starting earlier will take
priority.
• Until ... (eg., Until 13/8) – For a regular recording,
the last program that could be recorded is shown.
• Data Over –Can't record because the disc
management area of the disc is full.
• Cancel Once – A regular timer program is set to skip.
• Can't Rec – Not possible to record.
• Title Over – Can't record because there is already
the maximum number of titles on the disc (DVD: 99).
• Recording – The program is currently recording.
• Standby – The recorder is in timer recording
standby.
• nothing displayed – Another timer recording is in
progress.
6 To exit the timer recording screen, press HOME
MENU.
Tip
• To enter a title name for the timer recording in
advance, select Set Title Name and follow the on-
screen display.
Note
• If the timer program is too long to fit into the available
disc space, the message Time Over appears. The
program will record until the disc is full.
• If Optimized Rec (see Optimized Rec on page 72) is
set to On, the recorder will adjust the recording
quality to try and fit the recording on the disc. If the
program is too long even when recorded in MN1
mode, the message Time Over appears.