Basic Recording From The Tv; Setting A Timer Recording - Pioneer DVR-310 Operating Instructions Manual

Recording
05

Basic recording from the TV

VR mode Video mode
Follow the instructions below to record a TV program.
Recording starts immediately and continues until the
disc is full or you stop the recording.
1 Load a Recordable disc.
• if you load a new blank DVD-RW disc, the recorder
takes a short while to initialize the disc.
2 Use the CH +/– buttons to select the TV channel
to record.
The front panel display shows the channel number:
• While the recorder is stopped, you can also use the
number buttons on the remote to select the channel.
(For channel 6, press 6 then ENTER; for channel 24,
press 2, 4 then ENTER)
• If the recorder is stopped, you can also use the +/–
buttons on the front panel to select the channel
number.
34
En
HDD DVD
CH
CLEAR
AUDIO
ENTER
PAUSE
REC STOP REC
REC MODE
Channel preset
3 Use the REC MODE button to set the picture
quality/recording time.
• See Setting the picture quality/recording time on
page 33 for detailed instructions.
4 Use the AUDIO button to select the audio
channel to record.
See Changing audio channels on page 26 for more on
this.
• When recording in VR mode, if a broadcast is
bilingual, both audio channels are recorded, allowing
you to switch the audio channel on playback. The
only exception to this is when the picture quality is set
to LPCM, in which case you do need to select the
audio channel before recording.
5 Press REC to start recording.
If you want to set a recording end time, press the
button repeatedly. The recording time increases in 30
minute increments, up to a maximum of six hours. The
time the recording will end is shown on-screen and in the
front panel display. When the recording ends, the
recorder automatically switches into standby if no other
operation is being performed.
• To cancel the set recording time, press
• If you want to pause recording at any time, press
PAUSE. Press again to restart the recording. (If
recording in VR mode, a new chapter is started after
recording restarts)
6 To stop the recording, press
• If you set the recording time in the previous step, you
can still stop the recording anytime by pressing
STOP REC.
• Recording will stop automatically when there is no
more space on the DVD.

Setting a timer recording

VR mode Video mode
Using the timer recording features you can program up
to 32 timer recordings up to a month in advance. Timer
recording programs can be set to record just once, every
day, or every week.
There are three ways to program a timer recording; using
the Easy Timer Recording feature (see Easy Timer
Recording below), using the G-Code programming
system (see Timer recording using the G-Code™
programming system on page 36), or using manual timer
recording (see Setting a manual timer recording on
page 37).
You can set the recording quality for your timer recording
in the same way as for a regular recording, but with the
added option of an AUTO mode, which maximizes the
recording quality for the space available on the disc.
REC
REC.
STOP REC.